:
 
 
PRODUCT RANGE
Suite
Basin With Pedestal
Wall Hung Basin
Table Top Basin
Counter Basin
Closet
Pan & Urinal
Accessories
Seat Covers
Flushing System
 
ATM SERIES
A-Series
T-Series
M-Series
IPT-Series
Rustic Series
 
TECHNICAL SPECIFICATION
 
 
 
 
WALL HUNG BASIN
As shown in the picture, the rag bolt must be grouted into the cement/concrete wall. The bolts must be fixed to the cement/concrete wall. Allow setting and checking than install it using nut and washer.
 
 
 
COUNTER WASH BASIN
    At the beginning
 
1. A skilled or experienced person should install counter lavatories.
2. Avoid using adhesive with this product.
3. Check the waste area and supply tubing if required.
4. Do not open the lavatory from its protective carton untill you are ready for installation.
5. Please follow all local building and plumbing codes.
 
 
 
MATERIALS & TOOLS
Measure tape, Keyhole or saber saw, Hammer, Glasses, Rags or paper toweling, Drill (1/2 dia, drill bit or larger), Pencil, Sealant, Sharp Knife or Scissors.
 
 
 
INSTALLATION OF LAVATORY
Please Note: Please install it in a way that future removal from underneath the counter top is possible without damaging the counter top.
1. Please check the desired location for clearance between the back splash, faucet, fixture and cabinet.
2. Please cut the template.
3. Please carefully trace the template on the counter top as directed.
4. Please mark the faucet hole centerline on the counter top.
5. Please drill a 1/2" pilot hole on the inside of the cut line.
 
 
 
For Wood Counter Tops:
1.
Mark and per-drill the wood screw holes at the locations shown on the template.
2. Waterproof any exposed areas of wood.
 
 
 
For Marble Counter tops:
1.
Position the counter top upside down on foam padding to protect the surface. Mark and drill 3/6" holes 5/8" deep atthe locations shown on the template.
2. Use a setting tool and hammer to secure the anchors.
3. Check the waste area and supply tubing if required.
4.
Do not open the lavatory from its protective carton untill you are ready for installation.
5. Please follow all local building and plumbing codes.
 
 
 
For All Installations:
1.
If the counter top has not been installed, install it at this time.
2.
Drill the faucet holes according to the faucet installation instructions.
3.
Install the faucet to the counter top according to the manufacture's instructions.
4.
Install the drain to the lavatory according to the manufacture's instructions.
 
 
 
 
Home | Company | Factory | Quliaty | Market | Achivements | Inquiry | Contact Us
Develop By : Impression Inc.